Cotton field rotten bell should be early defense

August and September are the stages of cotton boll development, enrichment, maturity and boll opening. It is a key period for cotton production. At this time, it is rainy and humid, which is easy to cause the breeding and spread of various rotten bacteria. The worse the field microclimate conditions are. The more bells, the greater the damage to production. Therefore, the cotton field anti-corrosion bells must be caught before the rotten bells, focus on the following three measures:

Under the same meteorological conditions for drug protection, cotton fields with large populations, low terrain and prosperous populations are heavily polluted, and chemical agents should be sprayed from the end of July. It can be sprayed with 600% solution of 65% Daisen zinc water, or 400 times of wettable powder such as 50% methyl thiophanate or 50% mancozeb. The cotton boll on the fruit branches below the middle part of the cotton plant should be sprayed. Spray once every 7 to 10 days, even spray 2 to 3 times.

To reduce the humidity in the field, it is necessary to use the drainage ditch and mechanical pumping to drain the water as soon as possible. Conditional cotton-growing households can dig through the ditch to prevent waterlogging.

Improve the light transmission conditions in the field. The cotton bottom has poor light transmission. The cotton boll is susceptible to bacterial infection and causes rotten bells in a dark and humid environment. Empty branches, axillary buds, hair ears, and yellow leaves should be removed in time to enhance light transmission and reduce surface moisture.

Total 1 | <First <Prev 1 Next> Last> |
share to:

It is produced from quartz sand and high quality anthracite under high temperature in

an electric resistance furnace. 

By Barmak Breaker And Ball Mill Machining to crush it into different particle size to meet different  application.Being used for produce the abrasive tools. 

It is also fit for process the grind metals and non-metals material of low tensile strength, such as grey cast iron, brass, aluminum, stone, leather and hard rubber etc. Also can be used as refractory materials and in electronic industry.

 

Silicon Carbide(Barmak Breaker And Ball Mill Machining)

Silicon Carbide Properties ,Silicium Carbide ,Carborundum Grit

NINGXIA PANSON COAL AND CARBON CO., LTD , http://www.nxpanson.com