Strict ten major points of the acceptance of the initiative decoration mid-term
Construction acceptance socket cement TV decoration interior decoration decoration design bathroom ceiling material bathroom waterproof bathroom ceiling bathroom door bathroom design Tube Brackets,Fence Rail Brackets,Cast Aluminum Bracket Steel Tubing,Stainless Pipe Co., Ltd. , http://www.czsteelpipes.com
First, the waterproof layer should extend from the ground to the wall, 250mm above the ground. The height of the waterproof layer on the bathroom wall should not be less than 1800mm.
2. After the completion of the waterproofing project, a 24-hour storage test must be done.
Third, the power cord and the telephone line or network cable must not penetrate the same line tube. The horizontal distance between the power cord and socket and TV line and socket should not be less than 500mm.
4. A waterproof socket shall be installed in the toilet room and the switch shall be installed on the wall on the open side of the door.
5. Lines laid on the chisel wall or on the ceiling must be equipped with a sheath pipe. It is forbidden to directly bury the conductor in the plaster layer. The conductor shall not have joints and kinks in the pipe, and there shall be no exposed conductor in the ceiling.
Sixth, the general socket uses 2.5mm2 section and must design the grounding line, the air conditioner, the water heater and so on uses 4.0mm2 section.
Seventh, weak electricity: The telephone may choose to use 4 cores, the computer line uses 8 cores and 5 classes of lines, and the audio line recommends according to the sound equipment merchant to suggest to choose, the enthusiast must use the special high-grade line.
Eight, the indoor gas pipeline should be based on the main application. Gas pipelines shall be laid along the walls of non-combustible materials. When meeting with other pipelines, the following requirements shall be met:
(1) When laying horizontally parallel, the net distance should not be less than 150mm;
(2) When laying in parallel vertical direction, the net distance should not be less than 100mm, and it should be located on the outside of other pipes;
(3) When cross-laying, the net distance should not be less than 50mm.
9. Before tiling, the walls of the bathroom and the kitchen must be treated with a nap. That is, using cement > cement stuck to the wall to form a burr.
X. Carpentry Project:
1, all the plates are firm and no shaking.
2. The surface of all wood must not have dead knots, wormholes and cracks, and no skin. The hand feels smooth and delicate.