Generally speaking, there are more phenomena in the use of sanitary tiles in the form of tiles or arches. This is because the sanitary tiles are damp. The reasons for the dampness of sanitary tiles are as follows:

Why is the tile deformed during the renovation?

1. Moisture in the air (for example, Huangmeitian);

2. The floor is not dry, and the keel is reinforced with cement;

3, keel, wool bathroom tiles are too wet, using water-based glue;

4, the first floor and other humid environments have not been specially treated for moisture;

5. The section of the joint between the stone floor and the bathroom tile is not closed;

6, blisters (such as water pipes bursting, balcony water infusion, etc.);

7. In addition, the product itself and improper construction will also cause arching. For example, improper drying treatment, inadequate health, low water content, shallow back groove, insufficient expansion gap in construction, and too tight laying.

Precautions:

1. After paving, you should still pay attention to window ventilation, especially the bottom floor and room with east window. National and industry standards stipulate that the air humidity should be more than 70%, and moisture removal measures should be taken to avoid possible water vapor damage. Bathroom tiles are natural materials, and it is normal to produce a little gap, warp and discoloration during use. A small amount of bathroom tile sound, lacquer or cracking paint, cracking is also difficult to completely avoid.

2, the national standard stipulates that after the paving must be accepted within three days, the owner is best to keep a package of original bathroom tile samples, so that if there is a problem in the future, please check with the quality supervision department, you can tell whether it is the quality of the bathroom tile or paving Quality problems, bathroom tiles that have been paved can not be identified as their own quality problems.

3. Responsible subjects are responsible for product quality, construction quality and finished product maintenance quality. However, it must be reminded that the quality problems of wooden sanitary ware tiles sometimes appear in one stage, but often appear in the process of use, which will confuse the quality of the sanitary ware, the quality of the paving, and the quality of the use and maintenance. At this point, the after-sales service personnel must be calm and calm, carefully observe the test, and make judgments with caution.

4. From the point of liability, the moisture-proof isolation project should be implemented by the decoration company. If the bathroom tiles are also paved by the decoration company, then the responsibility for the problem will be clear in the future. However, if the pavement is responsible for the bathroom tile factory, then the factory should confirm that the indoor moisture-proof isolation is ready to be paved, and vice versa. Otherwise, once a dispute arises, the responsibility will be difficult to distinguish, and ultimately it will be the victim of the consumer.

Compensation Resistors Gauges

Compensation Resistors Gauges,Temperature Compensated Strain Gauge,32Ohm Temperature Compensated Strain Gauge,95Ohm Temperature Compensated Strain Gauge

Zhejiang Nanhua Electronic Technology Co., Ltd , https://www.nhloadcells.com