Renovation improves safety factor is the key

The safety of home decoration is often overlooked by people. In fact, accidents caused by wrong decoration methods are not rare. In general, the following points should be noted in the renovation project:

First, the home improvement should pay attention to the floor of the building not all paving marble. Marble is dozens of times heavier than floor tiles and wooden floors. If the floor is entirely covered with marble, the floor may become overwhelmed. Especially in the second floor or above, the weight of the ground decoration materials must not exceed 40 kg/m2 because of the house decoration not identified by the housing safety appraisal station.

Second, to carry out room decoration, do not arbitrarily wear holes in the load-bearing wall, dismantle the walls connecting the balconies and doors and windows, and expand the size of the original doors or windows or build windows and doors. This practice will cause partial cracks in the building and severely affect the earthquake resistance, thus shortening Building life.

Third, the decoration of balconies and bathrooms should use materials with small loads as much as possible because the over-loading of balconies can cause overturning.

Fourth, toilet water is a key link in the decoration. The general practice is, before decorating the toilet room, first stop the floor drain, put more than 5 cm of water, conduct the watering test, if it leaks, you must redo the waterproof; if you do not leak, you should also carefully lay the ground in the construction , Do not damage the waterproof layer and arbitrarily change the water and heating system.

Fifth, in the decoration of the house in order to pursue luxury, in the four walls covered with plates, ceilings inlaid with two or three-dimensional suspended ceiling, this kind of decoration practices are not desirable. Because the four walls are covered with plates, occupying a larger space will reduce the area of ​​the entire space, the cost is also high, and it is not conducive to fire prevention. A low ceiling will create a sense of depression in the entire room.

6. Use copper wire when selecting wires and avoid using aluminum wires. Due to the poor electrical conductivity of the aluminum wire, the wire is prone to heat, the connector is loose, and even a fire is caused during use. In addition, during construction, attention should also be paid to the fact that it is not possible to dig trench-embedded wires directly on the wall, and regular bushings should be used to prevent leakage and fire.

7. During the construction, attention should be paid to avoiding holes, holes, hanging ceilings, and installing art lighting fixtures in the concrete circular hole plate.

8. Interior decoration shall ensure the safety requirements for gas pipelines and equipment. Do not arbitrarily change or dismantle the pipeline so as not to affect the normal operation of the system. Also note that the net distance between the power line and equipment and the gas pipeline should not be less than 10 cm, and the net distance between the wire and the gas pipe should not be less than 3 cm.

9. Don't put the gas stove on the wooden cabinet in the kitchen decoration, and you can't wrap the gas valve in the wooden cabinet. Once the ground cabinet is on fire, the gas master valve will be difficult to close in the fire, and the consequences will be disastrous.

Entrance decoration Children's room Renovation window Marble Decorative space House Floor tile Marble floor Tiles Floor cabinets Kitchen doors Toilet doors Bathroom ceiling materials Bathroom doors Dimensions Bathroom dimensions Bathroom ceilings Bathrooms Waterproof bathroom leaks

Glass Sliding Door

Products characters

1.All the products produced by good quality building material factory need get through three strict inspections before packing: Raw material cutting test, Production process inspection, The finished debugging.

2.Providing customized service to apply each customer requirements, we will try our best to achieve 100% customer satisfaction.


Profile

1.High quality aluminum alloy profiles, thickness 1.2-2.0mm

2.Excellent quality thermal break aluminum profiles, thickness 1.4-3.0mm

3.PVC/UPVC material (need to be ordered)



Color

White/ Sliver / Grey / Champagne / Black / Wood grain / special color can be ordered


Glass Type

1.Single toughened glazing:6mm/8mm/10mm/12mm...

2.Double toughened glazing:5+12A+5mm/6+12A+6mm...

3.Laminated glazing:5+0.38PVB+5mm/6+0.76PVB+6mm...

4.Low-E glazing:Green/Blue/Brown/Golden...

5.Other glazing:frosted glass/crystal glass/art glass...


Mesh

1.Aluminum security mesh

2.Stainless steel security mesh

3.Solid iron security mesh

4.Mosquito net(Nylon,Stainless steel,Diamond)


Hardware

1.Germany brand

2.Japanese brand

3.Chinese top brand


Surface treatment

1.Anodizing

2.Powder coating

3.Electrophoresis

4.Fluorocarbon paint

Glass Sliding Door,Tempered Glass Sliding Door,Double Glass Sliding Door,Automatic Glass Sliding Door

Shenzhen Hongfa Automatic Door Co., Ltd. , https://www.spiralfastdoor.com