How to do the misalignment of the engraving machine
wire holder is made of high quality 304 stainless steel, It is easier to clean without rust, safe, healthy and durable, Prevent rust or chemicals from contaminating food and damaging health. Suitable for putting the wine glass holder. Goblet Rack,Stainless Steel Goblet Rack,Wine Glass Holder,Wine Glass Rack Shenzhen Lanejoy Technology Co.,LTD , https://www.szcoolingrack.com
How to deal with misalignment of engraving machine? Summarize the heroes of the heroes
During the carving process, the engraving machine presents various misalignments, such as misplaced left and right, up and down dislocation, x-axis misalignment, and z-axis misalignment. What is the cause of the misalignment of the engraving machine?
1. Check whether the way of carving software is correct or not;
2. Check the size of the gap of the Screw rod and the fastening screw of the polished rod for looseness;
3. Check if the software parameters are set correctly.
4 check the ground is not connected
5 is the computer is not a virus or may not be compatible with other inconvenience, usually advocated that the brand machine can be simply assembled chassis
6. Is the coupling above the front of the water-cooled spindle motor loose or damaged? Check to see if it can be replaced by hand or replace it.
7. Does the wire on the engraving machine beam to the machine control box engage the drag chain?
8. The driver's question: The layout of the driver itself may have misplaced the appearance of the original electronic equipment, this cause is the most; If the number of times presented is not much, and the speed is reduced a bit, sometimes it can be properly carved, this shows that the driver has not yet It is completely broken; if it is misplaced at the beginning, it is clear that the drive is completely broken. Action: Repair the drive or replace the drive.
9. The question of voltage: The power required by the engraving machine during the work is large. If the voltage is too low, the power supply to the driver is lacking. If the power is not reached, a misplaced image will be formed. This situation is usually misplaced with the Y-axis. The appearance may not be outside the voltage, perhaps on the same line someone has used high-power equipment such as welding. Treatment method: install a 5000-watt regulated power supply, but this regulated power supply can not exceed 5% error size, preferably within 3%.
10.Interface board, motherboard, adapter board doubt: If the interface board, motherboard, adapter board is broken, the engraving machine in the process of operation, a certain direction may be three axes are not moving, forming a carved misplaced.
The question of the spindle motor: If the stepper motor is probably a question of the servo motor, the whole machine does not move in a certain direction, and the hand-rotating screw rod does not move.
11. The question of the machine tool itself: a part of the machine tool may have loose questions, and impurities may appear on the surface of the machine. If the coupling is loose, it will be misaligned; the guide rails and the screw rod will not be on the long-term. Clean fueling will also show misplaced appearance; if the machine tool line is broken, it will also appear misplaced.
All parts of the control line contact bad (power line transmission line). Treatment method: remove all connections and reload
Contact ball
China leading manufacturers and suppliers of Wine glass holder,Goblet Holder, and we are specialize in Wine Rack,Hanging Wine Rack, etc.