6061, 6082, 6063 Aluminum Sheet
Other Heat Insulation Materials Rubber Plastic Insulation Material,Rubber Plastic Insulation Casing Pipe,Polyurethane Insulation Pipeline,Aluminum Silicate Fiber Blanket Zhengzhou Ou Nuo Building Materials Co., Ltd. , https://www.yuounuo.com
Our plant was established in 1993 , with 20 years export Copper &Aluminum products experierence .
    Our main products as belows :Â
    Copper Series : copper plate &sheet , copper strip , coppper pipe,copper rod , copper wire , cooper profile and so on.Â
    Aluminum Series : pure sluminum plate &sheet , aluminum alloy plate&sheet , aluminum plate $sheet for moulding ,
    aluminum coil, aluminum tread plate, aluminum round rod , aluminum square bar , aluminum pipe , industrial aluminum profile and so onÂ
Specification
Name: 6000 series Aluminum Sheet
Alloy: 6061, 6082, 6063 etc.
Temper: O, H112, T4, T6, T651 etc.
Thickness:Â 6-200mm
Width: Up to 1500mm
Surface treatment: mill finished, Print marks
Feature
Machinability: In the harder T 4 and T6 tempers it is good. It is notably less easy to machine in the annealed temper.
Forming: Easily cold worked and formed in the annealed condition. Stamping, bending, spinning, deep drawing are all readily accomplished using standard methods.
Welding: It has very good welding characteristics and may be welded by all of the common welding techniques.
Heat Treatment: Solution heat treat at 990 F for adequate time to allow for thorough heating and then water quench. Precipitation hardening is done at 320 F for 18 hours and air cool, followed by 350 F for 8 hours and air cooling.
Forging: It is capable of being hot forged at temperatures in the range of 900 F to 750 F.
Hot Working: Hot working may be done in the temperature range of 700 F to 500 F.
Cold Working: Cold working in the O temper condition is readily performed. The alloy is notably less easy to cold form in the T 4 and T 6 tempers.
Annealing: Annealing should be done at 775 F for 2 to 3 hours followed by controlled cooling at 50 f per hour down to 500 F, then air cool.
Aging: The aging precipitation heat treatment is done at 350 F for 8 hours followed by air cooling. This produces the T6 temper.
Application
Commonly used in the manufacture of heavy-duty structures requiring good corrosion resistance, truck and marine components, railroad cars, furniture, tank fittings, general structural and high pressure applications, wire products, pipelines, various toolings etc.
Â
Alloy
Chemical Component %≤
Si
Fe
Cu
Mn
Mg
Cr
Ni
Zn
Ti
others
Al
single
total
6061
0.4-Â 0.8
0.7
0.15-0.4
0.15
0.8-Â 1.2
0.04-0.35
\
0.25
0.15
0.05
0.15
remainder
6082
0.7-Â 1.3
0.5
0.1
0.4-Â 1.0
0.6-Â 1.2
0.25
\
0.2
0.1
0.05
0.15
remainder
6063
0.2-
0.60.35
0.1
0.1
0.45-0.9
0.1
\
0.1
0.1
0.05
0.15
remainder