Intelligent parking system design size and quantity
Pot Filler,Kitchen Faucet Pot Filler,Wall Mounted Folding Faucet,Wall Mounted Kitchen Faucet kaiping aida sanitary ware technology co.,ltd , https://www.kpaidafaucets-jm.com
1, parking lot system engineering quantity:
1) The longest distance between the entrances and exits of the vehicles (mainly separate from the entrances and exits) needs to be implemented in order to determine the number of pipe construction wires.
2) The condition of the road surface between the vehicle entrances and exits needs to be determined to determine the type of road surface (concrete, brick, or turf) for determining the size of the construction.
3) For entrances and exits at the same intersection, it is necessary to confirm whether or not to build a safety island for fixed system equipment. In addition, it is necessary to confirm whether the safety island needs to be tiled.
2, parking design size:
The entrances and exits are at the same intersection: For vehicles entering and exiting at the same position, the installation position of the entrance and exit management equipment must be determined according to the actual conditions on the site. When the passage width is not more than 5 meters, the entrance and exit equipment is shared by one station; when the passage width is greater than 5 meters, When the distance is less than 8 meters, the access passages shall be designed as separate lanes, and the automatic barrier gates shall also be designed as separate lanes; (Since the domestic vehicle steering wheel is located on the left side of the vehicle, the card readers at the entrances and exits shall also be installed in the corresponding positions, so the above two This arrangement is limited to the use within the community). When the access road is more than 8 meters wide, a safety island with fixed system equipment (typically 5.5 meters by 1.3 meters by 0.18 meters) must be established in the middle of the road. Only in this way can both the convenience of the owner and the traffic regulations be met.
The exits and entrances are not at the same intersection: When the vehicles in the community are located in different passages, the first one is to consider the direction of circulation of vehicles within the community, and that direction is convenient for appearance. Therefore, the passageway is designed to be an exit; otherwise, the Other passage is an entrance; if If there is no special requirement for the entrance and exit passages, the exit nearest to the administrative office is the exit.
The layout of the above equipment needs to be based on a principle that the entrance card reading equipment is no less than 3 meters away from the entrance fence, and the exit toll booth is not less than 2.6 meters away from the exit fence rails; the other entrance and exit card reading equipment should be placed on the straight passage as far as possible. If you can't avoid corners, you should set aside enough distance for vehicles to turn around to read and take cards.