Before punching work

(1) Check the lubrication of each part and fully lubricate the lubrication

(2) Check if the mold installation is correct and reliable;

(3) Check if the compressed air pressure is within the specified range

(4) Check whether the switch buttons are sensitive and reliable. Be sure to turn off the motor after the flywheel and clutch are disengaged. (5) Make the press perform several idle strokes to check the operation of the brake, clutch and control part.

(6) Check the main motor for abnormal heat, abnormal vibration, abnormal sound, etc.

(7) Adding lithium ester oil to the slider with a manual oil pump

(8) Check and adjust the feeder roller gap to the process requirements

(9) Check and keep the oil mister oil level up to the specified requirements

(10) When the motor starts, check if the direction of rotation of the flywheel is the same as the swing sign.

At work

(1) The lubricant should be pumped to the lubrication point with a manual lubricant pump.

(2) When the performance of the press is not familiar, the press should not be adjusted without authorization.

(3) It is absolutely forbidden to punch two sheets at the same time.

(4) If the work is found to be abnormal, stop working immediately and check it in time.

After work

(1) Disengage the flywheel and clutch, cut off the power supply, and release the remaining air.

(2) Wipe the press clean and apply anti-rust oil to the work surface.

(3) Make a record after each operation or maintenance.

Ball Valve

Stainless steel ball valves,Brass ball valves,Floating ball valves,Bibcocks,Flanged Ball Valve

Yuyao Gaobao Sanitary Ware Factory , https://www.gurberry.com