| Home>Bearing knowledge>How to remove imported bearings |
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131";
How to remove imported bearings
Source: Bearing network time: 2018-06-08
| /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089'; |
In the process of using imported bearings; timing eradication is very important.
How to properly remove imported bearings:
1. When the imported bearings are removed and viewed, the appearances should be recorded by shooting.
2, other; to recognize the amount of lubricant remaining and sample the lubricant; then remove the bearing.
3. The removal of the bearing is divided into rough washing and fine washing; and the metal mesh frame can be placed on the bottom of the used container.
1) When rough washing; remove the grease or adhesive with a brush at the top of the oil. If you change the bearing in the oil at this moment, be careful to damage the rolling surface due to foreign matter.
2), during fine washing; gradually change the bearing in the oil; must be carefully carried out.
4, the general use of the scavenger is neutral non-aqueous diesel or kerosene; sometimes also use warm lye, etc. as needed. No matter which type of scavenger is used; always filter and keep clean.
5, after eradication; immediately apply anti-rust oil or anti-rust grease on the imported bearings.
Recommend to friends comments close window
| Bearing related knowledge |
The common method of distinguishing automobile bearings The influence of the bearing device on the bearing life of the tapered roller bearing
PVD skills in preparation for the bearing assembly before using the bearing device
|
This article links to http://
Please indicate China Bearing Network http://
Previous:Summary of NSK Bearing Post-Code Designation (1)
Next: Steel Ball Overview and Development Process
Carbide Thrust Block
Carbide Thrust Block,Carbide Thrust Plate,Cemented Carbide Thrust Plate,Carbide Thrust Plate For Wear Parts
Zhuzhou Kerui Cemented Carbide Co., Ltd. , https://www.carbide-china.com