Cabinet errors and solutions
>>>The cabinets are cleverly upgraded to make the kitchen instantly change 1. The circuit diagrams before and after the hydropower reform were not preserved. The construction drilled above the pipeline, and water leaks or shorted wires. Cause unnecessary trouble! Solution: Keep the circuit diagram before and after the hydropower reform! 2. The tiles are easy to crack when empty, and the edges of small tiles are easy to crack! Solution: Workers can use a glass drill bit to break through the tile and use electric hammer to drill holes 3. There are no clear mistakes caused by the color of the countertops or doors, especially if they are changed after selection! Solution: There is a modified project, recorded in the best way (notebook)! 4. The phone number left by the customer to the factory, or the phone number reserved for the customer, no electricity or service area, delay time! Solution: Leave 1 more contact information! 5. The oven or disinfecting cabinet is underneath the cabinet. The socket is installed behind the appliance. Solution: A switch can be installed directly above the socket or elsewhere! The solution: to walk the refrigerator alone all the way! Solution: The distance from the ground should be around 1200! 8. There is no need to reserve a strong row of water heater power supply, access to the open line from a distance! Solution: Reserve one! Solution: Check it yourself and remind the design to make mistakes. Solution: Install a fake bar (fake board)! Construction Acceptance Electrical Sockets Glass Switch Ovens Glass Bricks Cabinets Cabinets Doors Cabinets Doors Glass Cabinets Floor Cabinets Drawers Cabinets Glass Doors Cabinets Doors Kitchen Doors Glass Doors Doors Kitchen Glass Sliding Doors Kitchen Tiles
Non-tapping screws are machine Screw, the pieceworker to be fastened must be tapped with taps in the screw hole in advance to match the screw threads.
The difference between tooth screws and other screws depends on whether they can be used together with nuts. Tooth screws can be used with nuts. And relative to the screws of other teeth, there are self-tapping screws. The nut of this kind of screw has no bow teeth. As for the standard teeth and fine teeth are only different pitch, it is the nut of the machine screw
Hex Machine screw,pan machine screw,flat machine screw,truss machine screw,Hexagon socket screws Shenzhen Lanejoy Technology Co.,LTD , https://www.szsmallcompressionspring.com
6. When traveling, the main power is off. The food in the refrigerator is spoiled. The main power is not turned off, and other appliances are not assured!
7. The location of the power supply between the cabinet and the cabinet is too low, between 800-1000. The small appliances on the counter block the plug, so it is troublesome!
9. Size errors, especially if the corners are not quite right, or if corners of parallelograms appear, installation is troublesome!
10. Drawers are at the corner, close to the wall cabinets, handles and other cabinets or walls fight, doors can not be fully open!