Now many people choose hardcover rooms when they buy a house, that is, developers can help the owners to take care of them in all aspects, and they can check in directly. This is very convenient for the owners, saves a lot of effort, and does not require experience. Annoying renovation, so it is very popular, but the hardcover room in the inspection and acceptance also have a lot of trouble, because there is a lot of places that need acceptance, today Xiaobian give everyone popularize, hardcover room floor acceptance of some small knowledge, hope Can help everyone!

First, the appearance of color difference should pay attention!

Acceptance first depends on whether the floor color is the same. If the color difference is too large, directly affect the appearance, you can request exchange; if the color is too uniform without color, look at the floor surface pattern is the same; if the pattern is almost the same, it may be artistic floor, rather than the so-called rare wood species material floor . Now some solid wood flooring material suppliers, using the general wood material, but in the surface paste a layer of valuable wood veneer to shoddy, reverse with aluminum foil paste, said to be moisture, in fact, is afraid to be seen The pattern is not the same as the front.

Second, check whether the floor will make a sound

Everyone can walk around on the floor during home inspections. The pace should be increased. Particular attention should be paid to the wall and door openings. Repeated movements should be found in areas with sound, and the specific location of the sound should be marked. In this case, it should be possible to request the removal of resurfacing. The site with sound is caused by the irregular operation of construction workers and the unqualified use of materials: Operation is not standardized, mainly reflected in the keel fixation is not solid; the failure of materials is mainly reflected in the ground keel has not been dried. In addition, some decoration construction units use dry keel construction without drying, and the surface looks like there are traces of drying. In fact, it did not dry.

Third, whether the floor has deformation

Acceptance method is to use 2 meters long ruler, leaning on the floor, the flatness should not be greater than 3 mm, more than a few measurements, if the passing rate of 80% or more to be considered qualified, otherwise it is unqualified. Sometimes people will find that the floor is partially arched. For solid wood flooring, it may be due to too tight or too dry (moisture content is too low), but for solid wood flooring, it is certainly poor quality flooring. Again, remind consumers that floor arching is a serious quality issue.

Fourth, whether the floor has locusts

It is more common to have locusts inside because of untreated keels. If it is found that it is not timely, when it is found that there is a blink, the floor has already been smashed. Crevices and scratches can be seen directly with the naked eye. However, there is a clear rule stipulated in the country that the floor scratches: Solid wood composite floor cracks should not be greater than 0.5 mm; scratches are mainly due to rough decoration, such as waxing method can not be repaired, it must be exchanged.

Tips: More practical decoration knowledge, real scene with the shoot, please pay attention to the palm of this site (micro signal: mall_jia).

Spring decoration knowledge ground acceptance

Cyclorama Light

Cyclorama Light,Cyclorama Wash Effect Light,Led Cyclorama Wash Effect Light,Cyclorama Led Lighting

EV LIGHT Guangzhou Co., Ltd , https://www.evlightpro.com