Description:

1. The R1 parameter values ​​in the program are used as a condition, and their function is to control the number of cycles of program processing.

2. R2 and R3 are the geometric parameters of the bevel chamfer (can be changed according to the change of the slope),

3. R4 is the tool radius parameter value.

4. R5 and R6 respectively represent the two right-angled sides of the triangle formed by the ball cutter core and the inclined surface (Fig. 4).

5. R8 is the height of each layer of the tool (note: the value of this parameter directly affects the surface quality and surface roughness of the right-angled surface).

6. The R9 parameter value is L1-L5 represented by the inward moving distance of the tool core (Fig. 6).

7. The R10 parameter value is the radius compensation value in the program change. $TC_DP6[1,1]=R10 is to input the value represented by R10 into the tool radius compensation value T1D1.

8. R11 is the height calculation in the Z direction.

9, G40 should also be used, because each cycle is compensated, so cancel at the end of each cycle, otherwise it will affect the operation of the program.

Previous page